BGS technic 7082 Manual De Instrucciones página 11

EMPTYING OLD OIL
1. Using an Adapter Hose from the kit, connect one end to the TOE New Oil Input Hose Fast
Connector, and the other end to the TOE Return Adapter Fast Connector.
2. Connect the Black Hose to the TOE Pressure Adapter Fast Connector. Place the other end of the
Black Hose in an appropriate disposal tank.
3. Turn the left Control knob to the Pressure position.
4. Turn the right Control knob to the Filling position.
5. Turn on the power switch of the TOE, view the used oil movement through the used oil View Flow
tube.
6. When all the used oil is transported from the TOE Used Oil Tank, turn off the power switch of the
TOE. Recover all the hoses to its original position.
7. Dispose of used oil and solvents in a proper manner as dictated by local environmental codes.
MAINTENANCE
1. Drain all hoses that were used in an appropriate oil disposal tank.
2. When finished using the TOE, coil the Red and Black Hoses and place in the TOE side holder.
Place the Adapter Fittings and Hoses back in their case. Store the case in the top-back of the
TOE.
3. When oil flow through the TOE becomes very slow, even with higher air pressure, replace the
TOE oil filter.
TROUBLESHOOTING
1. Turn on the power switch of the TOE but it does not operate.
check the power indicator is light or not.
Check the pump work or not
2. The hoses are connected but no oil flow is viewed from the View Flow tubes, even with higher air
pressure.
verify the correct settings of the Fuel Pressure-Recycle Control knob and the Filling-Recycle
Reverse Control knob.
3. The hoses are connected but no oil flow is viewed from the view Flow tubes, even with higher air
pressure, and the engine running.
Check to see if the direction of the oil inlet and oil return hoses are reversed.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed