GE IM-4 Manual Del Usuario página 25

3
CONNECT THE WATER LINE
• Squeeze the ends of the hose clamp (3) from
the kit with pliers and slide the clamp over the
water tube inlet.
• While still squeezing the clamp, insert the
plastic water line into the inlet as far as it will
go (approximately 1" [25 mm]).
• Then slide the clamp downward to capture the
plastic water line in place.
• Make sure the fill tube is aimed down.
• If the condensor mounting screw was removed,
secure the condensor to the refrigerator by
replacing the mounting clip and screw.
DO NOT OVER-TIGHTEN THE SCREW.
Water tube
inlet
4 ATTACH THE PLASTIC WATER
LINE
Fasten the plastic water line to the back of the
cabinet with adhesive-backed fasteners (5), spacing
the fasteners as shown to take up the slack in the
line.
Adhesive-backed fasteners
for plastic water line
All manuals and user guides at all-guides.com
Installation Instructions
3
25
WATER VALVE INSTALLED
5
Refer to the Water Line Installation Instructions
for connection to the home water supply. After
water line installation is completed, set the
icemaker power switch to ON .
The icemaking cycle will not begin until the
icemaker and freezer compartment reach
operating temperature, then icemaking
will begin automatically.