GE IM-4 Manual Del Usuario página 33

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

3
CONNECT THE WATER LINE
• Make sure there is enough plastic water line to
extend from the water valve to well into the water
tube inlet (15). Cut off any excess tubing.
• Squeeze the ends of the hose clamp (6) from the
kit with pliers and slide the clamp over the water
tube inlet.
• While still squeezing the clamp, insert the
plastic water line into the inlet as far as it will
go (approximately 1" [25 mm]).
• Then slide the clamp downward to capture the
plastic water line in place.
• Make sure the fill tube is aimed down.
Water tube
inlet
ROUTE AND ATTACH THE
4
PLASTIC WATER LINE
Route the plastic water line along the back of the
refrigerator to the water tube inlet.
Use the three adhesive backed fasteners (5) to
secure the plastic water line to the case back.
All manuals and user guides at all-guides.com
Installation Instructions
6
Adhesive-backed fasteners
for plastic water line
WATER VALVE INSTALLED
5
Refer to the Water Line Installation Instructions for
connection to the home water supply. After water
line installation is completed, set the icemaker
power switch to ON .
The icemaking cycle will not begin until the icemaker
and freezer compartment reach operating temperature,
then icemaking will begin automatically.
33

Publicidad

Tabla de contenido
loading

Tabla de contenido