DeWalt DCBL590 Manual De Instrucciones página 12

REMOVING BLOWER FROM BOX (FIG. 2)
NOTE: The blower and joystick tube assembly are attached when
shipped. Trying to pull one side out without the other may result in
damage to the cable (K).
1. Grab the blower handle (O) and the joystick (A) and removing
simultaniously.
2. Cut the plastic zip tie that is tethering the joystick to the blower.
3. Remove the rest of the parts and assemble as instructed below.
ASSEMBLY (FIG. 2 - 10)
CAUTION:
Ensure the battery-selection switch is in
the center "OFF" position to prevent the blower from actuating and the
battery is removed before attaching or removing the tubes. The tubes
must be fully assembled before use.
Tube Assembly
ATTACHING FLEXIBLE TUBE TO ELBOW TUBE (FIG. 3, 4)
1. Remove the tube clamp with cable clip (J) from the flexible tube
(G). Note the orientation of the clamp for when it is reattached.
2. Slide the flexible tube over the elbow tube (H) as shown in figure 3.
3. Keeping the clamp in the same orientation as it was before
removing it from the flexible tube, pull open the clamp with cable
clip and wrap it around the flexible tube where it attaches to the
elbow tube as shown in figure 4.
4. Slide the clamp bolt (U) through the clamp. Thread the hex nut (V)
onto the clamp bolt by hand.
5. Using the hex wrench (T), tighten the bolt until the clamp holds
the flexible tube securely to the collar and joystick tube. DO NOT
OVERTIGHTEN. Overtightening the clamp could result in
damage to the tool and will restrict the movement of the
joystick tube (F).
FIG. 3
G
H
ATTACHING FLEXIBLE TUBE TO JOYSTICK TUBE
1. Insert the tube collar (W) at the end of
the joystick tube (F) into one end of the
flexible tube (G) as shown in figure 5.
2. Pull open the tube clamp (I) and wrap
it around the flexible tube where it
overlaps the tube collar.
3. Slide the clamp bolt (U) through the clamp. Thread the hex nut (V)
onto the clamp bolt by hand.
4. Using the hex wrench (T), tighten the bolt until the clamp holds
the flexible tube securely to the collar and joystick tube. Do not
overtighten. Overtightening the clamp could result in damage to
the tool.
ATTACHING LOWER TUBE
1. Line up the channels (X) of the
lower tube (E) with the nubs (Y) on
the joystick tube (F) as shown in
figure 6.
2. Slide the lower tube (E) onto the
joystick tube (F).
3. Firmly twist the lower tube to lock
the nub completely into one of the two recesses of the lower tube.
10
FIG. 4
V
U
FIG. 5
W
G
F
FIG. 6
E
X
Y
F