Using The Jump-Start Function - Parkside ULG 17 A1 Instrucciones De Funcionamiento Y De Seguridad

can choose between different battery types.
The battery type must be correctly set before
starting the charging process:
12 V – regular: These batteries (lead-acid
„
batteries) are usually used in cars, trucks
and motorcycles. They have venting caps
and are often marked as "low-mainte-
nance" or "no maintenance". This battery
type is meant for transferring energy
quickly (e.g. starting an engine).
"Regular" batteries should not be
used for "Deep – Cycle" applications.
12 V Deep Cycle: These batteries are
„
usually also marked as "Deep – Cycle"
or "Marine". Batteries of this type are
usually larger than other battery types.
This supplies less short-term energy,
but a longer-term energy transmission.
These batteries can withstand a large
number of discharge cycles.
12 V – AGM/gel: The AGM battery
„
types are usually good deep – cycle bat-
teries. They have the best "service life"
when they are recharged before they
have been discharged by more than
50 %. At complete discharge they can
withstand about 300 charge cycles.
The battery type GEL is similar to the
battery type AGM. The voltage during
recharging is lower than in other lead-
acid batteries. If you use the wrong car
battery charger for a gel battery,
a reduced output or shorter service life
can be expected.
6 V – regular: Choose this mode for
„
commercial rechargeable 6-V batteries.
Note: If you connect a 12 V car battery
to a car battery charger and the car battery
charger automatically detects it as a 6 V
battery, it can be assumed that this 12 V car
battery is faulty and needs to be replaced.
Charge-start button
to switch between the following options and
start the charging process:
3 : Use this button
Fast Charge: fast charging
„
Normal charge: normal charging
„
(normal speed)
Start: briefly supplies 75 Ampere to
„
bridge batteries with a weak charge
or flat 12 V batteries for the purpose
of starting the engine
Note: In the Fast Charge mode the charger
automatically switches to maintenance
charging after a successful charging process
(the "Charged" LED lights up in green in the
digital display 6 ), provided the car battery
charger remains connect to the battery and
mains current.
Attention: Mode can only be terminated
by pulling the mains plug
repeatedly pressing the charge start button
(repeated pressing until no mode is
displayed).
Note: If the "Charged" LED in the digital
6
display lights up in green, the battery
is sufficiently charged and a repeated fast
or normal charging process is no longer
permitted.
z Using the jump-start
function
Always make all connections
as described and in the proper order. Other-
wise, the electronic system of the vehicle can
be damaged.
If proceeding contrary to the specifications
described, you will act at your own risks and
responsibility.
Attention: This function is not suitable for
batteries below 45 Ah. For batteries below
45 Ah, this function may damage the battery.
For diesel vehicles and large-volume gasoline
motors, higher currents than 75 A are needed
for starting at times.
Note: The car battery charger has an analysis
GB/IE/NI/CY/MT
Operation
7
or by
3
13