Package Contents; Parts Description; Technical Specifications - Parkside ULG 17 A1 Instrucciones De Funcionamiento Y De Seguridad

lead-acid batteries, deep – cycle (boat
batteries) or gel batteries:
For car and motorcycle batteries with
„
12 V/6 V and 8-250 Ah capacity
You can also regenerate discharged batteries
(depending on the battery type). The car
battery charger has a safety circuit against
sparking and overheating. Keep these instruc-
tions in a safe place. Ensure you hand over
all documentation when passing the product
on to anyone else. Any use that differs to the
intended use as stated above is prohibited
and potentially dangerous. Damage or injury
caused by misuse or disregarding the above
warning is not covered by the warranty or
any liability on the part of the manufacturer.
The device is not intended for commercial
use. Commercial use will void the guarantee.
Note: The car battery charger cannot charge
any electrical vehicles with
integrated rechargeable battery.
Note: No jumpstart of 6-V batteries possible.
z Package contents
Check the scope of delivery and
the device as well as all parts for
damage right after unpacking.
Do not put a defective unit or
defective parts into operation.
1 Car battery charger Ultimate Speed
ULG 17 A1
2 Quick contact connection terminals
(1 red, 1 black)
1 original operating instructions
z Parts description
1 Digital display button
2
Battery type button
3
Charge start button
4
"–" pole connection cable (black)
5 "+" pole connection cable (red)
6 Digital display
7 Mains cable
8 Fuse with cover
z Technical specifications
Input voltage:
Return current*:
Nominal output voltage: 6 V/12 V
Charge current:
Battery type with:
Housing protection type: IP 20
* = Return current means the current that
the car battery charger consumes from
the battery when no mains current is
connected.
Changes to technical and visual aspects of
the product may be made as part of future
developments without notice. Accordingly,
no warranty is offered for the physical dimen-
sions, information and specifications in these
operating instructions. The operating instruc-
tions cannot therefore be used as the basis for
asserting a legal claim.
Note: The maximum load current essentially
depends on the internal resistance of the con-
nected battery. This internal resistance
is determined by the following factors: ages,
capacity and type of connected battery.
GB/IE/NI/CY/MT
Introduction
230 V~ 50 Hz
< 5 mA
(no AC input)
2 A, 6 A,
17 A ± 10%
12 V/6 V and
8-250 Ah capacity
7