Beretta EXCLUSIVE MIX C.S.I. Manual Para La Instalación Y El Uso página 23

When ENTER is pressed, the previously set value
starts flashing (fig. 41)
- turn the domestic hot water temperature selector to
change the value
- press ENTER to confirm the new value. The digits stop
flashing (fig. 42)
- press ESCAPE to exit.
The boiler returns to the - - (OFF) status.
To reset, press the button (fig. 38).
MIX C.S.I.: programmable parameters
N° DESCRIPTION PARAMETERS
PAR.
1 GAS TYPE
2 BOILER POWER
3 INSULATION LEVEL OF BUILDING (+) (*)
10 DOMESTIC HOT WATER MODE
11 DHW CIRCUIT MAXIMUM SET-POINT
12 THIS PARAMETER IS NOT USED ON THIS MODEL. DO NOT MODIFY
13 THIS PARAMETER IS NOT USED ON THIS MODEL. DO NOT MODIFY
14 THIS PARAMETER IS NOT USED ON THIS MODEL. DO NOT MODIFY
20 THIS PARAMETER IS NOT USED ON THIS MODEL. DO NOT MODIFY
21 HEATING CIRCUIT MAXIMUM SET-POINT
22 THIS PARAMETER IS NOT USED ON THIS MODEL. DO NOT MODIFY
28 MAX HEATING POWER REDUCTION TIMER
29 FORCED HEATING SHUT DOWN TIMER
30 HEATING TIMER RESET FUNCTION
40 DHW THERMOSTAT OPERATING MODE
41 DHW PREHEATING FUNCTION
42 S.A.R.A. FUNCTION
43 S.A.R.A. BOOSTER FUNCTION
44 THERMOREGULATION FUNCTION
45 INCLINATION THERMOREGULATION CURVE (OTC) (*)
48 THIS PARAMETER IS NOT USED ON THIS MODEL. DO NOT MODIFY
50 THIS PARAMETER IS NOT USED ON THIS MODEL. DO NOT MODIFY
61 DHW ANTIFREEZE FUNCTION TEMPERATURE (ON)
62 HEATING ANTIFREEZE FUNC. DELIVERY TEMP. (ON)
85 SEMI-AUTOMATIC FILLING
86 AUTOMATIC FILLING PRESSURE (ON)
(*) parameters shown only with external sensor connected and parameter 44 in 1 (AUTO).
(+) for well-insulated buildings select values close to 20, for badly insulated buildings choose values close to 5.
Parameter 45 "Inclination of thermoregulation curve (OTC)"
The curve must be chosen according to the geographical area and the type of installation.
T m. - 20
OTC =
10 x
20 - T e.
UNIT OF
MEASURE
-
-
-
3 (External water-tank with thermostat)
4 (External water-tank with sensor)
° C
° C
min
min
-
-
°C
°C
bar
T m. = maximum rated temperature of heating water
T e. = minimum rated external temperature
23
parameter value
Fig. 41
Fig. 42
MIN MAX
1 Methane
2 LPG
3 Metan FR
26 (26kW)
30 (30kW)
34 (35kW)
5 20
0 (OFF)
1 (Istantaneous)
2 (Mini-tank)
40 60
45 80
0 20
0 20
0 1
0 (OFF)
1 (AUTO)
2 (ON)
0 (OFF)
1 (AUTO)
2 (ON)
0 (OFF)
1 (AUTO)
0 (OFF)
1 (AUTO)
0 (OFF)
1 (AUTO)
2,5 40
0
1
0 10
0 10
0 (disabled)
1 (enabled)
0.4 0.8
parameter number
DEFAULT PARAMETERS
(setted (setted by techn.
in factory) assist. centre)
1-2
26-30-34
5
1
60
60
80
5
1
80
40
15
3
0
1
1
1
1
1
20
4
6
1
0.6