Publicidad
Step
Step 4
Flip the ENDS (A and B) over.
å
Turn four BLACK 9/16" FLAT HEAD SCREWS (32S) into
å
the ENDS (A and B) until the shoulders of the SCREWS
rest on the surfaces of the ENDS.
NOTE: Do not overtighten the SCREWS.
å
Slide the END MOLDINGS (I) onto the ENDS (A and B).
å
Line up the grooves in the MOLDINGS over the heads of
the SCREWS in the ENDS.
NOTE: If the MOLDING comes up off of the SCREWS,
å
remove it and slide it on again.
NOTE: The MOLDINGS should be centered
å
on the ENDS.
www.sauder.com/services
A
I
Apply pressure with your hands
as you guide the MOLDINGS over
the SCREWS and onto the ENDS.
B
I
BLACK 9/16" FLAT HEAD SCREW
Shoulder
421934
32S
(4 used in this step)
Page 9
Publicidad
