Publicidad
Step 6
Turn two BLACK 9/16" FLAT HEAD SCREWS (32S) into the MODESTY PANEL (G) until the
å
shoulders of the SCREWS rest on the surface of the MODESTY PANEL.
NOTE: Do not overtighten the SCREWS.
å
Slide one of the MODESTY PANEL MOLDINGS (R) onto the MODESTY PANEL (G). Line up the
å
groove in the MOLDING over the heads of the SCREWS in the MODESTY PANEL.
NOTE: If the MOLDING comes up off of the SCREWS, remove it and slide it on again.
å
NOTE: The MOLDING should be centered on the MODESTY PANEL.
å
Flip the MODESTY PANEL (G) over and repeat this step to the other surface of the MODESTY
å
PANEL (G) with the remaining MODESTY PANEL MOLDING (R).
BLACK 9/16" FLAT HEAD SCREW
(4 used in this step)
R
Apply pressure with your hands
as you guide the MOLDINGS over
the SCREWS and onto the ENDS.
www.sauder.com/services
32S
Shoulder
G
R
421934
32S
G
R
R
Page 11
Publicidad
