Sauder Costa 421934 Instrucciones De Montaje página 16

Step 11
Separate the WIDE EXTENSION SLIDES (BB) from the WIDE EXTENSION RAILS (AA) as shown in the upper diagram
å
below. Be prepared, the parts are greasy.
Fasten the WIDE EXTENSION RAILS (AA) to the RIGHT END (A) and RIGHT UPRIGHT (D). Use four GOLD 5/16" FLAT
å
HEAD SCREWS (3S) through holes #1 and #3.
NOTE: For each WIDE EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
å
cartridge of the WIDE EXTENSION RAIL in to fi nd the other hole that lines up with the hole in the END and UPRIGHT. Turn
a SCREW into this hole.
NOTE: The WIDE EXTENSION SLIDES will be used later for the LARGE DRAWER.
å
BB
Push the black lever in and pull the SLIDE from the RAIL.
GOLD 5/16" FLAT HEAD SCREW
(4 used in this step)
Edge with
TWIST-LOCK®
FASTENERS
Open end
Page 16
Separate the WIDE EXTENSION SET (AA and BB)
from the NARROW EXTENSION SETS (CC and DD).
3S
D
4
3
2
1
AA
AA
A
4
421934
1
AA
2
3
www.sauder.com/services
Open end