Snapper SPV21675E Guía De Montaje Rápido

SPV21675E - NSPV21675E Overview
Bail Control
Recoil Rope
Handle
Cutting Height
Adjust Lever
Fuel Fill Cap
Mulching
Cover
Items that you will need
Unleaded Fuel (minimum 87 octane)
Utility Knife
Items Included
Side Discharge FreshStart
Deflector Preserver Cartridge
Mulching Plug SAE30W
Battery
(Installed) Grass Catcher
Oil Charger
© Briggs & Stratton Corporation
We reserve the right to improve our products and make changes in specifications, designs, and standard equipment without notice and without incurring obligation.
Quick Setup Guide
Self-Propelled Mower
1
Unpack the mower
• Remove the mower from the carton. Remove all packing materials from the mower.
• Locate and identify the items included with the mower.
2
Read the manuals
• Carefully read all the manuals supplied with the mower. They contain important safety, operating, and
maintenance information.
3
Unfold the handle
• Turn the knobs (A, Figure 1) on either side
of the lower handle 1/4 turn to retract the
locking pins.
• Raise the lower handle, aligning it with one
of the three sets of holes in the handle
bracket (most users will prefer the middle
position).
Ignition • Turn the knobs to release the locking pins
Switch and secure the lower handle.
• Loosen, but do not remove, the upper
knobs (B) on the handle. Remove the
cardboard slats.
• Raise the upper handle to the operating
Drive
position, and tighten the upper knobs.
Lever
Battery
4
Set up the recoil rope handle
Oil Fill and
Dipstick
• Hold the bail control against the handle,
and pull the recoil rope handle out to the rope
guide (A, Figure 2) on the handle. Hook the recoil rope
into the rope guide (it might be a tight fit).
3-in-1: Convert from mulching to bagging to side-discharge:
1
For mulching:
• Leave the mulching cover and
the installed mulching plug
(Figure 8) in place.
Figure 8
TM Fuel
2
To convert to
bagging:
• Lift the rear door, and remove
the installed mulching plug
(Figure 9).
Operator's
Figure 9
Manual
Models SPV21675E - NSPV21675E
5
•
•
Failure to read and follow instructions in the
operator's manual could result in death and/or
bodily injury.
•
•
B
•
A
6
•
•
•
•
Figure 1
•
•
•
A
•
•
•
Figure 2
• Holding the rear door open, attach the
grass catcher (Figure 10) to the rear
of the mower.
• Make sure the hooks (A, Figure 11) on
either side of the catcher frame hook
Figure 10
onto the rear door rod (B).
• Release the rear door (it will lay on top of
the grass catcher).
Figure 11
Questions?
Do not return to the store. We can help.
Call Customer Service Toll-Free
Or visit our website
Add oil and fuel
Move the mower outside to a flat, level surface.
Remove the oil fill cap (A, Figure 3). Add the entire contents of the
supplied oil container to the engine. Replace the oil fill cap.
IMPORTANT Mower is shipped without oil in engine.
Failure to add oil will result in engine damage.
Remove the fuel fill cap (B). Following the three-step instructions on the
FrestStart TM card, snap the fuel preserver cartridge into the bottom of
the fuel fill cap.
Add clean, fresh, UNLEADED fuel with a minimum of 87 octane, leaving
one inch of space from the top of the tank for fuel expansion.
IMPORTANT Fuel tank holds less than 1/2 gallon.
IMPORTANT DO NOT mix oil with fuel.
Replace the fuel fill cap, and wipe up any spills.
Start the mower
Charge the battery prior to use: Connect the battery charger (Figure 4)
to the battery connector (the connector coming from the battery), and
plug the charger into a 120-volt outlet for 24-48 hours.
Remove the charger from the battery connector, and connect the battery
connector to the engine harness connector (Figure 5).
Move the cutting height adjust lever (A, Figure 6) to the desired
cutting height.
Set the mower to mulch, discharge or bag. (See 3-in-1 instructions below.)
Hold the bail control (A, Figure 7) against the drive handle.
Turn and hold the ignition key (B) until the engine starts, but never
longer than five seconds. (If the engine does not start within five
seconds, wait twenty seconds and start again.)
If manually starting, pull the recoil rope handle (C) until the
engine starts.
To engage the drive system, slowly pull the drive lever (D) back. To
increase ground speed, slowly pull the drive lever farther back. To
decrease ground speed, slowly release the drive lever.
To disengage the drive system, release the drive lever.
To stop the engine and blade, release the bail control.
3
To convert to side-discharge:
• Make sure the mulching plug is installed in the
rear of the mower.
• Lift the mulching cover (A, Figure 12).
• Install the side discharge deflector (B) onto
the mower deck. Make sure the upper tabs (A,
Figure 13) of the deflector are hooked behind
the mulching cover rod, and the deck tab
B sticks up through the locking slot (B).
A
• Release the mulching cover (it will lay
on top of the side discharge deflector).
1-800-317-7833
www.snapper.com
B
A
Figure 3
DANGER
Fuel stabilizer is a hazardous chemical.
IF SWALLOWED, call a physician immediately
Fuel stabilizer contains:
2,6-di-tert-butylphenol (128-39-2) and
aliphatic petroleum distillate (64742-47-8).
Running engines give off carbon monoxide, an
odorless, colorless, poison gas. Breathing carbon
monoxide can cause nausea, fainting, or death.
Operate this product ONLY outdoors.
Keep exhaust gas from entering a confined area through
windows, doors, ventilation intakes or other openings.
DO NOT operate this product inside any building or
enclosure, even if windows and doors are open.
Figure 4 Figure 5
A
Figure 6
B
A
C
D
Figure 7
A
B
Figure 12
A
B
Figure 13
Form No. 7101634 (I.R. 1/5/200
TP 1099-5325-IR-WB