Metz MECABLITZ 58 AF-1 digital Manual Del Usuario página 9

Servo mode
Slave mode is a simple wireless flash mode in which the slave flash unit always
triggers a flash as soon as it receives a light impulse from the camera flash unit.
Adjustment procedure for servo flash mode
• Select a mode for the camera flash unit without pre-
BEEP
flash.
Select
Remote
• Press the
FB
on the display.
Set
• Use the
"Remote". The selected menu item will be highlighted
with a dark bar.
• Press the
Servo
the
immediately.
Set
• Press the button
to the normal display. If the button
the screen will automatically return to normal display
after 5 s.
Servo
In general, only the manual flash mode
MZoom 35
P1/1
the SERVO flash mode.
Para Sel
This is automatically selected after switching the
SERVO flash mode on.
key repeatedly until "Select" appears
Sel
and keys to select the menu item
button and select "Servo" by pressing
Set
and buttons. The setting will take effect
repeatedly until the screen returns
is not pressed,
M
is possible in
Setting partial lighting or reflector position (MZoom)
• In SERVO mode, press the
Para
until the set partial lighting or reflector position is
+
–
shown. By using the and
tial lighting (for example 1/8) or reflector position
(for example MZoom 50) can be set.
Wait for all of the flash units involved to become flash-ready.
Once the slave flash unit is flash-ready, its AF measuring beam
blinking.
+
Slave groups and remote channels cannot be set in slave mode. The
camera flash unit may not work in the wireless remote mode!
+
In the case of cameras from Canon, Pentax and Sony the built-in camera
flash unit or the flash unit in the flash shoe of the camera must work in the
Canon E-TTL, Pentax P-TTL or Sony preflash TTL or Sony ADI mode.
+
When it comes to cameras from Nikon and Olympus the built-in camera
flash unit or the flash unit in the flash shoe of the camera must be switched
M
to the manual mode.
+
In Panasonic cameras the slave mode is not supported by the built-in
camera flash unit. The slave mode can only be used if a flash unit in the
flash shoe of the camera operates in the manual
Servo
button repeatedly
MZoom 50
P1/64
Para Sel
buttons, the par-
will start
M
flash mode.
k