Connecting The Drain Hose; Electrical Connections; Technical Data - Hotpoint Ariston AQUALTIS AQM8F 49 U Instrucciones De Uso

Ocultar thumbs Ver también para AQUALTIS AQM8F 49 U:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Connecting the drain hose

! We advise against the use of hose extensions; if it is
absolutely necessary, the extension must have the same
diameter as the original hose and must not exceed 150 cm
in length.

Electrical connections

Before plugging the appliance into the electricity socket,
make sure that:
• the socket is earthed and complies with all applicable
laws;
• the socket is able to withstand the maximum power load
of the appliance as indicated in the Technical data table
(see opposite);
• the power supply voltage falls within the values indicated
in the Technical data table (see opposite);
• the socket is compatible with the plug of the appliance.
If this is not the case, have the socket or the plug
replaced.
! The machine must not be installed outdoors, even in
covered areas. It is extremely dangerous to leave the
appliance exposed to rain, storms and other weather
conditions.
! The mains socket must remain within easy reach after the
washer-dryer has been installed.
! Do not use extension cords or multiple sockets.
All manuals and user guides at all-guides.com
Connect the drain hose to
drain duct piping or a wall
drain located between 65
and 100 cm above the floor,
making sure it is not bent
at all.
Alternatively, rest the
drain hose on the side of
a washbasin or bathtub,
fastening the duct supplied
to the tap (see figure).
The free end of the hose
should not be underwater.
! The cable should not be bent or compressed.
! The power supply cable and plug must only be replaced
by authorised technicians.
Warning! The company shall not be held responsible in the
event that these regulations are not respected.

Technical data

Model
AQM8F 49 U
width 59.5 cm
Dimensions
height 85 cm
depth 64.5 cm
from 1 to 8 kg for the wash programme
Capacity
from 1 to 6 kg for the drying programme
Electrical
please refer to the technical data plate
fixed to the machine
connections
maximum pressure 1 MPa (10 bar)
Water connections
minimum pressure 0.05 MPa (0.5 bar)
drum capacity 62 litres
Spin speed
up to 1400 rotations per minute
Wash: programme
using a load of 8 kg.
Energy rated
Drying: the smaller load must be dried by
programmes
selecting the "L1" dryness level. The load
according to
must consist of 2 sheets, 1 pillowcase and
regulation
1 hand towel;
EN 50229
the remainder of the load must be dried by
selecting the "L4" dryness level.
This appliance conforms to the following
EC Directives:
- 2004/108/EC (Electromagnetic Compatibility)
- 2006/95/EC (Low Voltage)
- 2002/96/EC
EN
; temperature 60°C;
3

Publicidad

Tabla de contenido
loading

Tabla de contenido