Makita BCL180 Manual De Instrucciones página 5

of the button, it is not locked completely.
Insert it fully until the red part cannot be
seen. If not, it may accidentally fall out
of the tool, causing injury to you or
someone around you.
Do not use force when inserting the
•
battery cartridge. If the cartridge does
not slide in easily, it is not being inserted
correctly.
Switch action
009986
CAUTION:
Before inserting the battery cartridge
•
into the tool, always check to see that
the switch trigger actuates properly and
returns to the "OFF" position when
released.
To start the tool, simply pull the switch trigger.
Release the switch trigger to stop.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched
•
off and the battery cartridge is removed
before carrying out any work on the tool.
Disposing of Dust
CAUTION:
Empty the cleaner before it becomes
•
too full, or the suction force weakens.
Be sure to empty out the dust inside the
•
cleaner itself. Failure to do so may
cause the filter to be clogged or the
motor to be damaged.
1. Switch trigger
1
1
009992
In order to drop dust sticking on the filter in
the capsule, tap the capsule 4 or 5 times
with your hand.
009993
Now point suction inlet downwards, turn
capsule in direction of arrow in diagram, and
disconnect capsule slowly and straight.
NOTE:
Dust may spill out when capsule is
•
opened, so be sure to set a garbage
bag beneath capsule.
1
009994
5
1. Suction inlet
2. Capsule
2
1. Capsule
2. Suction inlet
1
2
1. Prefilter
2. Capsule
2