Carlson Pet Products MAXI Manual Del Usuario página 8

STEP 7
Connect the assembled gate to the wall by inserting the flat ends
of the threaded rods into the semi-circle slot at the bottom of each
maxi mounting bracket. Adjust the length of the threaded rods
appropriately to allow for installation. After proper insertion, the
threaded rods will lock in place.
NOTE: Install one side of the gate completely before attempting to install the second side.
STEP 8
Adjust the threaded rods so that an equal amount of spacing is
distributed between the 4 corners.
Then, using a wrench, tighten the locking
nuts to lock the gate in place.
NOTE: The gap between the gate and wall should not exceed more than 2.5 inches. Make the
appropriate adjustment to ensure you have installed your gate safely.
ENGLISH
8