i.safe MOBILE M53A01 Manual Del Usuario página 5

Malfunctions occur.
The housing of the device shows damage.
The device has been subjected to excessive loads.
The device has been stored improperly.
Markings or labels on the device are illegible.
We recommend that a device displaying errors or in which an error is suspected be sent back
to i.safe MOBILE GmbH to be checked.
Use of this device assumes that the operator observes the conventional safety regulations and
The following safety regulations must also be complied with:
Inside ex-hazardous areas the covers of all interfaces must be closed.
To ensure the IP-protection, it has to be ensured that all gaskets are present
and functional. There must be no large gap between the two halves of the housing.
The device may only be charged outside ex-hazardous areas using the i.safe PROTECTOR 2.0
or i safe PROTECTOR 3.0 USB-cable or other equipment approved by i.safe MOBILE GmbH.
Whenn using the IS-SH1.1 headset, the headset must be securely fastened to the ISM interface.
Physical connections to equipment other than the IS-SH1.1 headset are only allowed outside
ex-hazardous areas using the i.safe PROTECTOR 2.0 and i.safe PROTECTOR 3.0 USB-cable
or other equipment approved by i.safe MOBILE GmbH.
The device may only be charged at ambient temperatures between +0°C ... +40°C.
The device may not be exposed to any aggressive acids or alkalis.
The device may only be used in zones 1, 2, 21, or 22.
Only accessories approved by i.safe MOBILE GmbH may be used.
In case the device has a hand strap, it is not allowed to do the adjustment of the hand strap in
ex-hazardous areas.
FURTHER SAFETY ADVISES
Do not touch the screen of the device with sharp objects. Dust particles and nails may scratch
the screen. Please maintain the screen clean. Remove dust on the screen with a soft cloth
gently, and do not scratch the screen.
Do not put the device in environments with excessive temperatures, as this could lead to
Charge the device under indoor conditions only.
Do not charge the device in environments with much dust or humidity.
The device may only be discharged at ambient temperatures between -20
Do not use the device in areas where regulations or legislatives prohibit the use.
induction ovens or microwaves.
Do not attempt to open or repair the device. Improper repair or opening can lead to the
the device.
.
. Only authorized personnel are allowed to repair
.
.
°C ... +60°C.
EN 5