Megger MIT400/2 Serie Guia De Inicio Rapido página 3

EN
Warnings and user guide
This document provides important safety information. Keep with the accessories. DO NOT DISCARD
■
Megger provide a range of accessories and leads sets for use with the MIT400/2 series insulation
■
testers.
Models suitable for charging are identified in the MIT400/2 user manual.
■
Battery Voltage should be changed to 1.2V if NiMh are used. See section 13 Setup of the user manual.
■
In all cases it is the responsibility of the user to employ safe working practices and verify that the
■
system is safe before connection.
NOTE: The instrument and accessories must be used only by suitably trained and competent persons
Use only Megger approved Charger, and follow the instructions provided.
Dispose of old batteries in accordance with local regulations.
■
Safety warnings:
Safety warnings must be read and understood before use.
WEEE Directive
The crossed out wheeled bin symbol placed on Megger products is a reminder not to dispose of
the product at the end of its life with general waste. Megger is registered in the UK as a Producer
of Electrical and Electronic Equipment. The Registration No is WEE/HE0146QT. For further
information about disposal of the product consult your local Megger company or distributor or visit
your local Megger website.
G
Symbols on the accessories:
G
Warning – read user manual
12 - 15 V
Charger voltage
Charger polarity
Charging output
polarity