Tristar PZ-2964 Manual Del Usuario página 15

2). PUT THE PLUG INTO AN EARTHED 230V SOCKET
3).THE TEMPERATURE SCALE CAN BE SET IN ACCORDANCE WITH THE FOOD;
THE CONTROL LAMP IS ON TO SHOW THE PAN IS HEATING.
COOKING
1). AFTER THE PAN HAS BEEN TURNED ON, WAIT 5-10 MINUTES,: AS SOON
AS THE CONTROLLAMP WILL LIGHT, YOU CAN START COOKING.
2). IF THE FOOD IS COMPLETELY DONE, THE TEMPERATURE CAN BE KEPT
BY PUTTING THE TEMPERATURE SCALE TO 'WARMKEEP'.
If the lamp goes off, this is not an error, the automatic temperature regulator is
-
in function.
- If there is some noise, this is not an error: the noise comes from the heater and
the heat plate
- Do not put your hand under the reflector; do not put any inflammable material
on the pizza pan.
3. after use
1) After use put the temperature scale to OFF
2) Pull the plug out of the socket, and then take out the automatic temperature regulator
from the heat plate
Caution: Because the temperature leader of the temperature regulator is very hot after
using the heat plate, let the heat plate cool down before pulling it out.
3) After cooling down, clean the temperature regulator with a dry and soft cloth.
Caution measures to be taken by operating the heat plate
The surface of the heat plate is non-stick, so take care as following:

Do not use sharp objects made of metal.
Do not use a sharp knife to cut the food on the surface.
