3. Insert the ignition key (10) into
the opening provided for it next
to the battery (9).
4. Before switching the apparatus
on, make sure that it is not touch-
ing any objects.
5. To switch the
apparatus on,
press the release
button (16) and hold it down
while pressing the starting lever
(17). Let go of the release but-
ton.
6. To switch the apparatus off, let
go of the starting lever (17).
Due to the intelligent energy man-
agement system, the motor starts
after a delay.
After switching off the equip-
ment, the blade continues to
turn for several seconds. Do
not touch the moving blade.
There is a risk of injury.
Charging the battery
Do not expose the battery to
extreme conditions such as
heat or impact. Risk of injury
from escaping electrolytic so-
lution! After eye/skin contact,
rinse the affected areas with
water or a neutraliser and
consult a doctor.
Charge the battery in a dry
room only. Prior to attach-
ing the charger, check that
the battery's outer surface is
clean and dry. There is a risk
of injury due to electric shock.
•
•
1
2
•
•
Insert/remove rechargeable
battery
Recharging the battery
Only use the charger from the pack-
age to charge the battery.
Charge the battery before the first time
of use. Do not briefly charge the bat-
tery several time in a row.
If a fully recharged battery lasts for
considerably shorter operating times,
the battery is used up and needs to
be replaced. Only use an OEM spare
battery available from our Customer
Service.
Always take heed of the applicable
safety instructions as well as the envi-
ronmental protection regulations and
information.
The warranty excludes all defects
caused by improper handling.
Switch off the apparatus, remove
the ignition key (
for the blades to come to a stand-
still.
1. To insert the battery (9) push the
battery along the guide rail into
the appliance. It locks into place
audibly.
2. To remove the battery (9) from the
appliance, press the release but-
ton (9a) on the battery and pull
the battery out.
Switch off the apparatus, remove
the ignition key (
for the blades to come to a stand-
still.
GB
IE
10) and wait
10) and wait
37