N + 1 Psu Leds; Gigabit Port Leds - Promise Technology Vess A2200 Guia De Inicio Rapido

N + 1 PSU LEDs

The Vess A2200 uses an N + 1 PSU arrangement. Each PSU has a Status LED. After boot up, check the
LEDs on each power supply on the back of the device. These LEDs will light green to indicate normal
operation. A red or amber LED indicates a problem or unit failure. See the Product Manual for a complete
description of PSU and other LED indicators.
Figure 19: LEDs on Power Supplies for Vess A2200

Gigabit Port LEDs

Check the network connection on the rear panel to make sure the system is accessible for configuration. The
Gigabit Ethernet ports have Link/Act and Speed LEDs located below each of the four ports.
Figure 20: Network LEDs on rear panel
Gigabit Ethernet port LEDs
The LED on the left side below each port lights when connected, flashes when there is activity on the port and
remains dark no connection has been established.
PSU 1 LED
15
Vess A2200 Quick Installation Guide
PSU 2 LED PSU 3 LED