Appliance-specific safety instructions
for cordless pruners
■
Always wear a hard hat, hearing protection
and safety gloves. Also wear eye protection to
prevent splashes of oil or saw dust from falling
into your eyes. Wear a dust mask to protect
yourself from dust.
■
Never use the appliance while standing on a
ladder.
■
Do not lean too far forwards while using the
appliance. Ensure you are standing firmly and
keep your balance at all times. Use the supplied
carrying strap to spread the weight evenly on
the body.
■
Wear sturdy, non-slip boots.
■
Do not use the appliance in the rain.
■
Do not use the appliance near overhead power
lines. Maintain a minimum distance of 10 m to
overhead power lines.
■
Do not stand under the branches that you want
to cut off, to avoid injuries due to falling
branches. Be aware of branches that may spring
back, to avoid injuries. Work at an angle of
approximately 60°.
■
Be aware that the appliance can kick back.
■
Keep an eye not only on the branches being
cut, but also on falling material, to avoid trip-
ping.
■
After 30 minutes' work, take a break of at least
one hour.
■
Always wear protective gloves.
■
Cover the guide rail and the chain during trans-
port during transport and storage using the
cover.
■
Do not use the appliance in a potentially explo-
sive environment containing flammable liquids,
gases or dusts. The sparks generated by the
machine could ignite the vapours or gases.
■
The power outlet used must be suitable for the
plug. To avoid electrical shocks, never try to
modify the plug.
PAHE 20-Li C3
■
Never remove the plug from the power supply
by pulling on the power cable. Always pull the
power plug itself. Do not drag or carry the
appliance using the power cable. Keep power
cable away from heat, oil, sharp edges or
moving parts.
■
Remove the battery pack from the appliance
after completion of work or during cleaning
and maintenance.
■
Avoid unintentional starting of the appliance.
■
Appliances with defective switches must be
repaired immediately to avoid damage or
injuries.
■
Store the appliance outside of the reach of
children. Only those who are fully acquainted
with these operating instructions and the appli-
ance itself may operate the appliance.
■
Maintain power tools carefully. Check for
misalignment or binding of moving parts,
breakage
of parts and any other condition that may affect
the power tool's operation. If damaged, have
the power tool repaired before use. Many
accidents are caused by poorly maintained
power tools.
■
Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting edges
are less likely to bind and are easier to control.
■
Therefore, have the appliance checked by quali-
fied specialists. Use only the replacement parts
recommended by the manufacturer.
GB │ IE
│
7
■