Silvercrest SKMP 1300 D3 Instrucciones Breves página 17

Never touch the device with wet hands.
If the device falls into water, disconnect
the mains plug immediately. Only then
is it safe to remove the device.
Only plug the mains plug into the wall
socket after the device has been com-
pletely assembled.
Only connect the mains plug to a prop-
erly installed and easily accessible wall
socket whose voltage corresponds to
the specifications on the rating plate.
The wall socket must still be easily ac-
cessible after the device is plugged in.
Ensure that the power cable cannot be
damaged by sharp edges or hot spots.
Do not wrap the power cable around
the device.
Even after it has been switched off, the
device is not completely disconnected
from the mains. In order to fully discon-
nect it, pull out the mains plug.
Keep the power cable away from hot
surfaces (e.g. hot plates).
When using the device, ensure that the
power cable cannot be trapped or
crushed.
When removing the mains plug from the
wall socket, always pull on the plug and
never the cable.
Disconnect the mains plug from the wall
socket ...
... if there is a fault,
... when you are not using the food pro-
cessor,
... prior to assembling or disassembling
the food processor,
... prior to cleaning the food processor
... during thunderstorms.
Do not use the device if there is visible
damage to the device, accessories or
power cable.
In order to avoid any hazards, do not
make modifications to the device.
Never reach into the rotating blades. Do
not touch rotating parts with spoons or
similar utensils. Keep long hair and loose
clothing away from the rotating parts.
Please remember that the blades contin-
ue to turn for a short time after switching
off the device.
Please remember that the blades of the
blade assembly are very sharp. Never
touch the blades with your bare hands
in order to avoid cuts.
When washing manually, the water
should be sufficiently clear so that you
can see the blade assembly easily to
avoid injuries caused by the very sharp
blades.
Never put your hands between the drive
arm and the housing. There is a risk of
injury from crushing when folding
down.
Do not touch rotating parts with spoons
or similar utensils. Keep long hair and
loose clothing away from the rotating
parts.
Always ensure that the speed control is
set to 0 before you plug the mains plug
into the wall socket.
Switch the device off and pull out the
mains plug from the wall socket before
you exchange auxiliary or additional
equipment moving in operation.
When the blender jug is not attached, the
cover must be mounted. Otherwise the
device will not work, in order to avoid in-
juries.
Place the device exclusively on a level,
dry, non-slip and waterproof surface, so
that it can neither fall nor slip off.
The mixing mechanism must not be op-
erated continuously for longer than
10 minutes, or the blender for longer
than 3 minutes. You must then allow the
device to cool down to room tempera-
ture.
The device must never be operated with-
out the jug.
Never place the device on a hot sur-
face, e.g. a hot plate.
15
GB