Power Supply - Zeiss SL 120 Instrucciones De Uso

12 Cable for fixation lamp
to be connected to the power supply
13 Two threaded holes
for fastening screws for fitting the base plate to instrument table
14 Red mark
indicating the mid-position of the height adjusting range
15 Brightness control
continuously adjustable, no slit light in the left final position, in the
right final position corresponds to maximum illumination intensity
16 Hole for mounting the fixation lamp
right and left
17 Connection for electrical connection of fixation lamp
right and left

Power supply

2
1
Fig. 6 Power supply
The power supply NAG SL 6 V provides the voltages for the slit lamp
(illumination and fixation lamp). It is a short-circuit-proof unit.
Nominal line voltages: 100 ... 240 V at 50 / 60 Hz.
Power consumption:
Front panel:
1 Power ON/OFF rocker switch
2 Fastening plate with four threaded holes
Rear panel:
3 Connector for the cable for slit illumination
4 Connector for fixation lamp cable
5 Connector for DigiCam Illuminator
6 Connector for mains cable
Caution
You may use only a mains cable with straight cable connector.
000000-1363-329 SL 120 11.07.2006
max.75 VA.
Description
Fig. 5
3 4 5 6
Power supply rearview
11