General Assembly - TEUFELBERGER HipSTAR FLEX Información Del Fabricante E Instrucciones De Uso

11,5 mm e2e / 12,7 mm e2e
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 16
GENERAL / ASSEMBLY
WARNING!
This product may only be used as a replacement
part for hipSTAR FLEX from TEUFELBERGER,
but never separately without the other com-
ponents of hipSTAR FLEX. Separately, that is,
without the other components of hipSTAR FLEX,
it is NOT type-examined and DOES NOT comply
with the specified standards.
This replacement part may be exchanged only
by a competent person or under the supervision
of such competent person. For this task, be sure
to observe these Instructions for use!
Such replacement can also be performed by
TEUFELBERGER for a fee. To do so, please
send the product to the above-mentioned
address! If you have any doubts as to whether
you have the necessary knowledge and expe-
rience, it is absolutely necessary that you con-
sult a competent person or TEUFELBERGER.
TEUFELBERGER is not responsible for direct,
indirect or incidental consequences/damage
occurring during or after the use of this product
and resulting from improper use, especially
caused by incorrect assembly.
For replacements, only use the replacement
part approved by the manufacturer and supplied
together with this Manufacturer's Information
brochure. Never use it for any purpose other
than the one described below. Before pro-
ceeding to use hipSTAR FLEX again, be sure
to verify that the replacement part has been
exchanged correctly. If you do not have the
necessary experience, skills, and knowledge for
such task, please consult a competent person
or the manufacturer.
When using this product, be sure to observe the
Manufacturer's Information brochure for hip-
STAR FLEX. All pieces of information provided
with regard to transport, storage, cleaning, and
service life also apply to a hipSTAR FLEX with a
replaced hipSTAR FLEX e2e.
hipSTAR FLEX e2e is just one of the compo-
nents of hipSTAR FLEX. Replacing it makes it
WARNING
The use of our products can be dangerous. Our products may only be used for their intended purpo-
se. They must particularly not be used for lifting as specified in EU directive 2006/42/EC. The custo-
mer is responsible that the user has been trained in the safe use of the product and in accompanying
safety precautions. Be aware of the fact that the product can cause damage if wrongly used, stored,
cleaned or overloaded. Check national safety regulations, industry recommendations and standards
for local requirements. TEUFELBERGER
TEUFELBERGER Group.
6
possible to continue using the system provided
that all the other components of hipSTAR FLEX
are in an appropriate condition. To assess the
condition, please observe the Manufacturer's
Information brochure for hipSTAR FLEX, or
contact a competent person.
The person responsible for the replacement
makes an entry about the replacement of hip-
STAR FLEX e2e on the inspection record sheet
appended to the Instructions for Use of hipSTAR
FLEX and confirms this entry by adding the date
and his/her signature.
ASSEMBLY
Before proceeding in accordance with the
following assembly instructions, please consider
if you really have the knowledge and experience
necessary for this task. Otherwise, be sure to
consult a competent person or the manufacturer
of the PPE.
WARNING!
The hipSTAR FLEX system comprises the fol-
lowing textile components: the present hipSTAR
FLEX e2e as well as OD Loop 7mm T, and OP
8mm e2e P.
Pay attention to the different lengths and article
numbers of OD Loop 7mm T:
7350116 for hipSTAR FLEX 11.5mm
7350133 for hipSTAR FLEX 12.7mm
Before replacing the hipSTAR FLEX e2e with
rope end stitching in your hipSTAR FLEX, be
sure to verify that the remaining components
can still be used. Keep in mind that, for the
textile components OD Loop 7mm T and OP
8mm e2e P, the maximum service life is 2 years
(OD Loop 7mm T) and 3 years (OP 8mm e2e
P), respectively, from the initial removal of the
product from its undamaged, light-protected
package. For the assessment of the condition,
be sure to observe the Manufacturer's Infor-
mation brochure for hipSTAR FLEX, or contact
a competent person. We recommend using a
new hipSTAR FLEX if it becomes necessary to
exchange several components.
and 拖飞宝
are internationally registered trademarks of the
®
®

Publicidad

Tabla de contenido
loading

Tabla de contenido