Safety Advice - BGS technic 9791 Manual De Instrucciones

SPECIFICATION
Power Supply: 12V vehicle battery
Operation Enviroment: 0°C - 40°C,
relative humidity <80%
Storage Enviroment: -10°C - 50°C,
relative humidity <85%
Dimensions: 147 x 82 x 29 mm (main body)
Weight: about 165g
Intended Use
This fuel injector tester is designed to test each injector individually. The Tester has 4 pulse modes,
this helps to locate identify stuck, leaking or burnt-out conditions.

SAFETY ADVICE

•
To avoid personal injury, electrical shock and damage to vehicle parts, turn off the engine before
using the tester.
•
Never smoke or have open flames near vehicle.
•
Never permit fuel to spill on hot engine parts.
•
Always operate the vehicle in a well ventilated area. Never inhale exhaust gases or fuel vapors.
•
Always keep yourself, tools and test equipment away from all moving or hot engine parts.
•
Do not short the battery's positive and negative terminals.
•
Do not touch any conductor which may contain high voltage.
•
Always follow vehicle manufacturer's warnings, cautions and service procedures.
•
Always wear approved eye protection and safety gloves.
•
After test, connect all the connections correctly which you have disconnect.
Terminals
1
2
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Petrol Injector Tester, 12V
Panel
3
4
5
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
1 Black Clip, used to connect to the
negative terminal of battery.
2 Red Clip, used to connect to the
positive terminal of battery.
3 Pulse Output Terminal, used to
connect to the injector.
7
4 Display
5 Mode set key
6 Pulse set key
6 7 Pulse signal indicator
BGS 9791
Description
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed