Indesit BAN 40 FNF Serie Manual De Instrucciones página 54

• The temperature of the freezer is dangerously high: the food
GB inside must not be eaten. The freezer will maintain a temperature
of approximately 0°C.
To switch off the buzzer, press the RESET ALARM button.
Press a second time to display the set value on the freezer
status bar, switch off the ALARM LED and restore normal
operation.
The refrigerator and the freezer do not cool well.
• The doors do not close properly or the seals are damaged.
• The doors are opened too frequently.
• The temperature that has been set is too high ( see Start-up and
use ).
• The refrigerator or the freezer have been over-filled.
The food inside the refrigerator is beginning to freeze.
• The temperature that has been set is too low ( see Start-up and
use ).
The motor runs continuously.
• The SUPER FREEZE button has been pressed (rapid freezing):
the yellow SUPER FREEZE light is on or flashing ( see
Description ).
• The door is not closed properly or is continuously opened.
• The outside ambient temperature is very high.
The appliance makes a lot of noise.
• The appliance has not been installed on a level surface ( see
Installation ) .
• The appliance has been installed between cabinets that vibrate
and make noise.
• The internal refrigerant makes a slight noise even when the
compressor is off. This is not a defect, it is normal.
Early ending of functions
• Electrical disturbance on the network or brief interruptions of the
power supply.
The freezer status bar LEDs do not indicate the set
temperature, and are lit in a constant manner.
• Contact the Technical Assistance Centre.
54