Lenco IR-2100 Manual Del Usuario página 9

Setting the ALARM
Note: If you make a mistake at any point, press BACK button to go back to the previous
screen
1. Press the SELECT button.
2. Press Tune up or down until the display says<Configure>.
3. Press the SELECT button.
4. Press Tune up or down until the display says<Clock>.
5. Press the SELECT button.
6. Press Tune up or down until the display say<Set Time>.
7. Press the SELECT button.
8. Press Tune up or down to swap between Yes/No and press the SELECT button. If you choose
'No' then the alarm is turned off. The display says Alarm is off for 3seconds, then returns to the
radio station display.
9. If you choose 'Yes' then the display enables you to set the time for the alarm.
If the radio was streaming when the alarm was set and the unit turned off, the Alarm will reconnect
to the radio to alert the customer when the Alarm expires.
If the media player was streaming music from a PC when the alarm was set and the unit turned off,
the Alarm 'beeps' to alert the customer when the Alarm expires. When the user silences the alarm
the Media player will try to reconnect to the stream it was last playing.
All manuals and user guides at all-guides.com
< Configure >
< Clock >
< Set Alarm >
Enable Alarm
Yes/No
Alarm is off
Set Alarm
7:50
-8-