- It is necessary to replace batteries every two years, even if the unit has not been used for long periods.
- Never leave discharged batteries in the unit (remote control and collar): leakage could damage your
CANICOM 1000.
Maintenance
- Avoid cleaning the unit with volatile liquids such as solvents or cleaning fluids. Use a soft cloth and
neutral detergent.
- In order to maintain water tightness, we recommend the replacement of the seal located in the receiver
collar every year.
Troubleshooting
Should your CANICOM 1000 stop working or develop a fault, first read this user's guide over, then check
the batteries and replace them if necessary and retry. Also check that you are using the product correctly.
If you encounter any problem, re-code the receiver collar with the remote control (ref. coding procedure).
Re-initialise the system by removing the battery from its housing, then with a metallic tool (e.g. screwdriver,
scissors) touch each of the 2 battery contacts for 2 seconds approximately (ref. Diagram 7). Insert the battery
again: One beep is emitted, indicating the battery is in correct position.
Diagram 7
Reset: connect
the 2 supports of
the battery
Restart your CANICOM using the remote control.
If the problem persists, contact your distributor.
Depending on the extent of the malfunction, you may have to return your product for service and repair.
For all repairs, please supply the following:
- the complete product
- the proof of purchase (invoice or sales receipt)
If you omit one of these items, the After Sales Service will have to invoice you for any repair costs incurred.
All manuals and user guides at all-guides.com
Gb - 25