Intended Use - BGS technic 6679 Guia De Inicio Rapido

Twin Wheel Separating Tool Set, 4 pcs.
TOOLS
1 Spindle with Inner Bearing
2 Inner Rim Push Block
3 Outer Rim Pull Hook (Large)
4 Outer Rim Pull Hook (Small)
IMPORTANT
Read the instructions and safety information carefully before working with this kit and keep the
manual in a dry and good accessible place.

INTENDED USE

This tools set is made to separate twin wheels on HGV and LCV vehicles and saves time when
removing corroded wheels. The included hooks can be installed between the two rims to force the
rims apart prior to removal. The tool set is suitable for using with air impact tools.
IMPORTANT INFORMATIONS
Our products are designed to be used correctly and with care for the purpose for which they are
intended. No liability is accepted by the BGS technic for incorrect use of any of our products, and the
BGS technic cannot be held responsible for any damage to personnel, property or equipment when
incorrect using the tools. An incorrect using of this tool set will also invalidate the warranty.
•
Always lubricate the spindle with Molybdenum Di-sulphide grease before using.
•
The following instructions are for guidance only. Please refer to vehicles manufactures data:
•
The use of this wheel separator tool is purely down to the user's discretion. BGS technic
cannot be held responsible for any damage caused what so ever, that have been caused by
incorrect use.
•
lt is our policy to continually improve our products and thus we reserve the right to alter
specifications and components without prior notice. lt is the responsibility of the user to ensure
the suitability of the tools and information prior to their use.
•
Do not use this tool set for other purpose for which it is designed.
•
Observe the general safety instructions for garages.
•
Keep your work area tidy and clean. Areas or corridors which are untidy increase the risk of
injury.
•
Always wear approved eye protection and safety gloves, when using this tool set.
•
Check the condition of the tool regularly and do not use it if it is damaged.
•
Do not over tighten the spindle or apply excessive force, as this may damage both the tool and
the component.
•
Keep children and other unauthorized persons away from the work area.
•
Do not allow children to play with the tool or its packaging and keep this tool out of the reach of
children.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
BGS 6679
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed