Sauder Hutch 420654 Manual Del Usuario página 8

Step 4
Flip the ENDS (A and B) over.
å
Turn four BLACK 9/16" FLAT HEAD SCREWS (32S) into
å
the ENDS (A and B) until the shoulders of the SCREWS
rest on the surfaces of the ENDS.
NOTE: Do not overtighten the SCREWS.
å
Slide the END MOLDINGS (C) onto the ENDS (A and B).
å
Line up the grooves in the MOLDINGS over the heads of
the SCREWS in the ENDS.
NOTE: If the MOLDING comes up off of the SCREWS,
å
remove it and slide it on again. Center the END
MOLDINGS (C) on the ENDS (A and B).
Apply pressure with your hands
as you guide the MOLDINGS over
the SCREWS and onto the ENDS.
C
BLACK 9/16" FLAT HEAD SCREW
(4 used in this step)
Page 8
Shoulder
A
32S
Apply pressure with your hands
as you guide the MOLDINGS over
the SCREWS and onto the ENDS.
Shoulder
C
420654
B
www.sauder.com/services