S2 / S3 / E-VAC2000 / BDC1330
Primary filter shaker
Automatic primary filter shaker
On models with an automatic primary filter shaker, the filter
shaker will be automatically activated at the start and end of
the operating cycle, respectively after starting the vacuum
cleaner and after all the motors have stopped (1 - Fig. 5).
Diagram A (see bottom of page - work phase sequence).
Manual primary filter shaker
In relation to the quantity of material vacuumed and if indicator
(9 - Fig. 5) is red, turn the vacuum cleaner off and use knob
(1 - Fig. 9) of the manual filter shaker.
Stop the vacuum cleaner before using the filter shaker.
Do not shake the filter while the vacuum cleaner is on,
as this could damage the filter.
Wait before restarting the vacuum cleaner, to allow the dust to
settle. Replace the filter element if the indicator remains red
(9 - Fig. 5) even after the filter has been shaken (consult the
"Primary filter replacement" paragraph).
Emergency stopping
Press Stop button (5 - Fig. 5). The vacuum cleaner stops.
The motors and internal components of the vacuum
cleaner will still be electrically powered.
To start the vacuum cleaner again, press the buttons of each
single motor or turn main switch(1 - Fig. 5) to "0" and then to
"I" again.
GB
0
I
C343
Figure 9
WARNING!
WARNING!
Motor 2
Automatic
filter shaker
Motor 1
10
2
Emptying the dust container
■
Before proceeding with these operations, turn the
vacuum cleaner off and disconnect the plug from
the power socket.
■
Check the class of the vacuum cleaner.
Before emptying the container it is advisable to clean the filter
(see "Primary filter shaker").
■
Standard and L version not suitable for vacuuming
hazardous dust
▪
Release dust container (1, Fig. 10), with lever (2),
then remove and empty it.
▪
Make sure the seal is in perfect condition and
correctly positioned.
▪
Place the container back in position and secure it
again.
Plastic bag
You can use the plastic bags supplied by our sales network
(Fig. 10A).
Versions for dusts harmful to health
■
Classes L, M, H suitable for vacuuming hazardous and/
or carcinogenic dust (class H).
Dust Bag
Class M vacuum cleaners are supplied with the dust bag -
code 81584000 (Fig. 11).
Class M vacuum cleaners must always be used with this bag
installed. If the bag isn't installed or is installed incorrectly, this
could create health risks for persons exposed.
Safe Dust Bag
Class H vacuum cleaners are supplied with the dust bag -
code 40840010 (Fig. 12).
Class H vacuum cleaners must always be used with this bag
installed. If the bag isn't installed or is installed incorrectly, this
could create health risks for persons exposed.
Power input
Motor 3
operating
2
2
time
0
I
8
WARNING!
A diagram
Automatic
filter shaker
10
T (s)
0
I
STOP
01/2015