Time Zone Setting; Date Setting; Alarm Setting - TFA 30.3014 Manual Del Usuario

Note:
The unit will still try to receive the signal every hour despite it being manually set. When it does receive the signal, it will
change the manually set time into the received time. During reception attempts the DCF tower icon will flash. If
reception has been unsuccessful, then the DCF tower icon will not appear but reception will still be attempted the
following hour.

TIME ZONE SETTING:

The time zone default of the Weather Station is 0. To reset the time zone:
1. The current time zone value starts flashing.
2. Use the IN key to set the time zone. The range runs from
hour interval.
3. Press the SET key to confirm and enter the "Date setting" mode or exit the setting mode by pressing the CH key
LCD 2 DATE SETTING:
The second section of the LCD shows the weekday and date, Alarm ((1)) time or Alarm ((2)) time. It also shows the
Alarm ON/OFF icons ((1)) and ((2)).

DATE SETTING:

Year (flashing) Date (flashing) Month (flashing) Weekday (flashing) Date (flashing)
Time Zone (flashing)
0 to 9 and then runs from -9 back to 0 in consecutive 1-
The date default of the Temperature Station is 1.1. or WE 1. in the year
are received, the date is automatically updated. If the signals are not received, you can adjust the date manually. To do
this:
1. Press the SET key after completing the time zone setting in order to enter th e year setting (flashing). Reset the
year by pressing the IN key. The range runs from
2. Press the SET key again to enter the month and date display (flashing).
3. Using the OUT key, set the month required. Using the IN key, set the date required.
4. Press the SET key again to enter the weekday display (flashing).
5. Using the IN key, set the weekday required.
6. Press the SET key once more to confirm and exit the manual

ALARM SETTING:

Alarm time
1. Press and hold down the AL1 key until the alarm time display flashes.
2. Use the IN key to set the hour and the OUT key to set the minutes. Pressing these keys continuously moves the
hours consecutively by 1 and the minutes consecutively by 5.
3. Either press the AL1 key once more to confirm and return to the nor mal display or do not touch any buttons for
around 15 seconds to confirm the set time.
4. To activate the alarm function, press the AL1 button once for Alarm 1. You should now see the Alarm ((1))
symbol to represent the Alarm 1 being ON.
5. To de-activate, press the AL1 button once again.
6. The steps for setting, activating and de-activating Alarm 2 are the same, but using the AL2 button instead of AL1.
2003. Once the radio-controlled time signals
2000 to 2029.
setting.
Alarm icon