WEG W22 Magnet Drive System Guía Rápida página 6

- Change the content of P0402 according to the motor rated
11 speed.
- Press "Save".
IMPORTANT: it is not necessary to change the content of
P0403, because it is automatically set at end of the oriented
start-up according to:
12
P0403 = (P0402 x P0431)
- Change the content of P0404 according to the motor rated
13 power (hp).
- Press "Save".
IMPORTANT: parameter P0405 will be visible only if the cards
ENC1, ENC2 or PLC11 are connected to the inverter.
14
- Set P0405 according to the number of pulses per revolution
(PPR) of the encoder.
If necessary, change P0406 according to the type of motor
15
ventilation. To do that, press "Select".
IMPORTANT: if the motor stator resistance is not available, the
16 value of P0409 must be kept at zero.
Note: Only for PM sensorless or PM with encoder.
IMPORTANT: W22 Magnet motor line has a single
configuration of six poles, regardless the speed; therefore, the
value of P0431 must be kept at 6.
17
On W50 Magnet motor line the pole number might be six or
eigth. Please look for this information on the motor's nameplate
or datasheet.
- Change the content of P0433 according to the motor
inductance Lq (mH).
18
- Press "Save".
Note: Only for PM sensorless or PM with encoder.
IMPORTANT: the value of P0434 is always smaller than
P0433.
- Change the content of P0434 according to the motor Ld
19
inductance (mH).
- Press "Save".
Note: Only for PM sensorless or PM with encoder.
- For type of control [006] PM with encoder or [007]
sensorless PM:
Change the content of P0435 according to the motor
20 constant Ke.
- For type of control [002] V/f Adjustable:
Change the content of P0444 according to the motor
constant Ke.
6 | W22 Magnet Drive System
®
120
To end press "Reset".
and W50 Magnet
26.1 A
1500 rpm
1500 rpm
0 Hz
20 hp
20 hp
34.80 mH
34.80 mH
17.0 mH
17.0 mH
271.0
PM sensorless or with encoder
100
V/f adjustable