Powerbuilt 648990 Guia De Inicio Rapido página 3

6. Position the flaring yoke and adapter directly over the hole in the end of the tubing. See figure f.
Slowly turn the "T" handle of the flaring yoke clockwise while guiding the adapter into the hole
in the tubing. See figure g.
7. Tighten the "T" handle until the tapered surface of the flaring adapter is flush with the tapered
surface of the hole in the flaring yoke. See figure h.
8. Turn the "T" handle of the flaring yoke counterclockwise to loosen until the adapter clears the
newly flared tubing end. Loosen the wing nuts on the flaring bar and remove the tube from the
flaring bar. Examine the bubble flare for cracks, distortion or other faults. If faults are found, cut
off tubing end and repeat flaring process. See figures i and j.
Figure (f)
Figure (h)
2
Figure (j)
Figure (g)
Figure (i)