Device Description; Installation; Installing Accessories; Inserting The Battery Pack - Kärcher HD 4/11 C Bp Manual De Instrucciones

Safety instructions for accessories
Also read the safety instructions for the battery pack
5.968-653.0 before initial startup
Symbols on the device
The device may not be connected to the pub-
lic drinking water network.
The high-pressure jet must not be directed at
persons, animals, live electrical equipment or
at the device itself. Protect the device from
frost.
Safety devices
CAUTION
Missing or modified safety devices
Safety devices are provided for your own protection.
Never modify or bypass safety devices.
The safety devices are set and sealed by the manufactur-
er. Adjustments are performed only by customer service.
Pressure switch
When the trigger on the high-pressure gun is released,
the pressure switch switches off the high-pressure
pump and the high-pressure jet stops.
The pump switches on again when the trigger is pulled.

Device description

Overview of the unit
See graphics page
Hubcap
1
Sliding skid/standing skid
2
Type plate
3
Nozzle storage for triple nozzle
4
Transport retainer for surface cleaner
5
Push handle lock
6
Push handle
7
High-pressure nozzle
8
High-pressure nozzle marking
9
EASY!Lock spray lance
10
EASY!Force high-pressure gun
11
Safety latch
12
Trigger
13
Safety lever
14
EASY!Lock high-pressure hose
15
Rechargeable battery pack
16
Indicator lamp eco
17
Eco button
18
Battery level indicator
19
Battery compartment cover
20
Battery pack release
21
Battery compartment
22
Hose storage compartment
23
Spray lance holder with a clamp for transport
24
10
Nozzle storage compartment for rotary nozzle (rota-
25
ry nozzle only included in the scope of delivery of
the "Plus" variant)
Power switch
26
Handle
27
Nozzle holder
28
EASY!Lock high-pressure connection
29
Handle
30
Water connection
31
Detergent suction hose with filter and detergent
32
dosing unit
Spray lance holder without a clamp
33
sieve
34
Hose spout
35
Union nut
36
Fastening the hubcaps
 Fasten the hubcaps.

Installing accessories

Note
The EASY!Lock system connects components quickly
and safely via a single turn of the quick-release thread.
1. Fit the high-pressure nozzle onto the spray lance
with the marking facing upwards.
2. Tighten the high-pressure nozzle hand-tight
(EASY!Lock).
3. Connect the spray lance to the high-pressure gun
and hand-tighten (EASY!Lock).
1.
4. Release the push handle lock.
5. Pull the push handle out to the end position.
6. Connect the high-pressure hose to the high-pres-
sure gun and high-pressure connection of the de-
vice and tighten hand-tight (EASY!Lock).

Inserting the battery pack

1. Swing up the lid of the battery compartment.
2. Insert 2 structurally identical, charged 36 V battery
packs into the battery compartment until they audi-
bly latch into place.
3. Close the cover of the battery compartment.
Note: For instructions on charging and using the battery
packs, see the separate operating instructions for the
battery pack and charger.
English

Installation

2.