Replacing Dual Burner Injectors - Franke OPERA POC 6 3GAV-D-O Manual De Instalación Y Servicio

POC 6 3GAV-D-O / POI 6 3GAV-D-O / POL 6 3GAV-D-O / POT 6 3GAV-D-O POC 6 3GAV-D-O / POI 6 3GAV-D-O / POL 6 3GAV-D-O / POT 6 3GAV-D-O

Replacing Dual burner injectors

The burner is equipped with two injectors to
independently supply the burner's inner and
outer ring.
Replace the central ring injector as described
above.
Proceed as follows to replace the outer ring cock:
– Unscrew the two screws that clamp
plate A in place, see photo 4.
– Remove injector B, see photo 5.
– Correctly screw in the injector and
refasten the plate in place.
Fig. 4
Fig. 5
Accessing the hob
To access the tray containing the functional
parts, proceed as follows:
– Remove the grids, burner caps
and flame-spreaders;
– Remove the knobs, sliding them off their
pins;
– Remove the screws that fix the burners
to the hob;
– Lift the hob.
IMPORTANT: When converting the appliance to
a different type of gas, place the corresponding
sticker (supplied as an accessory) in the
special space on the data plate. For operation
with LPG (G30 or G31), the minimum flame
adjustment screw must be fully screwed down.
These appliances are supplied in cat. II 2H3+.
– 11 –
EN