Cembre B500ND Manual De Uso Y Mantenimiento página 11

3 SEC.
The capacitive menu selection button may not work if touched using objects or
when wearing gloves, therefore always operate the button using a bare fi nger.
4.2) Choosing the "release mode"
The phase of discharging the oil into the tool's tank can be carried out in two diff erent ways, de-
pending on the mode set in the menu:
Release
mode
SMART
factory setting
MANUAL
To change the "release mode", proceed as follows:
- Select screen 8 from the "main menu" (Ref. to section 4.1).
- Hold finger on the button (7) until a confirmation "beep" is heard. The choice made is shown
by cursor position under the pictogram.
4.3) Enabling/disabling the LED Worklights
LED
ON
LED
OFF
4.4) Return to original factory settings / fi rmware version
Select screen 10 from the "main menu" (Ref. to section 4.1). To return the tool to its factory settings,
hold finger on button (7) until a confirmation "beep" is heard.
RESET
The RESET screen also shows the fi rmware version of the control board.
SW:S1J96900
11
To make a selected screen operational and appear at each start up of the
tool, operate the touch button for at least 3 seconds; a continuous beep
will confi rm the setting.
Associated
pictogram
By releasing the operating button (3) the oil is returned in full to
the tool reservoir only following automatic shut-off of the motor.
During the return phase, pressing the buttons enables the ram
stroke to be interrupted at any point so as to be able to restart from
this position in the next work phase, thus saving time and energy.
To return the oil to the tool reservoir it is necessary to press and
hold the release button (6).
During the return phase, by releasing the button it is possible for
the ram stroke to be interrupted at any point so as to be able to
restart from this position in the next work phase, thus saving time
and energy.
LED
OFF
LED
ON
BEEP
Function
(factory setting is LED ON)
Select screen 9 from the "main menu" (Ref.
to section 4.1). To deactivate or reactivate
operation of the LED Worklights, hold the
finger on button (7) until a confirmation
"beep" is heard.