Cembre B500ND Manual De Uso Y Mantenimiento página 7

To replace the battery, remove it by pressing the release button (9) (Ref. to Fig. 1), then insert the
new battery, sliding it into the guides until it locks.
The display shows the operational parameters of the tool; to customise, proceed as described in
section 2.7.
Select the appropriate die set for the connector.
Open the latch (41) and release the upper die holder (42) (Ref. to Fig. 2).
Insert one die into the upper die holder (42) until locked by the ball (83) and one die into the
lower die support (49) until locked by the spring clips (62) (Ref. to Fig. 2).
Close the head.
Insert the conductor into the connector (Ref. to Fig. 3).
Position the connector between the dies and ensure the correct location of the crimp (Ref. to
Fig. 4).
NOTE: when more than one com-
pression is required, proceed
according to the sequence and
direction indicated in the fi gure
opposite.
Ensure that the latch and the upper die holder are fully secured, otherwise damage
may occur during tool operation.
2.2) Die advancement
Press operating button (3) (Ref. to Fig. 4) to activate the motor-pump and advance the
lower die.
To halt the advancement, release operating button (4) and the motor will cut out.
Make sure the dies are exactly positioned on the desired crimp point otherwise
re-open dies following instructions as per section 2.4 and reposition the connector.
2.3) Compression
By keeping the operating button (3) pressed, the motor continues to operate and the ram will
gradually move forward until the two dies touch.
The motor will stop automatically when the set pressure has been reached.
To perform a full compression, press and hold the operating button (3) until the
motor stops automatically.
7
terminal
2 3
1
3
1 2
1
2
3
connector