To Do A Check Of The Transmission Oil Level; Troubleshooting Schedule; Troubleshooting - Husqvarna R 214 Manual Del Usuario

Ocultar thumbs Ver también para R 214:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

12. Turn the oil filter clockwise by hand until the rubber
seal is in position, then tighten a half turn more.
13. Fill the oil slowly through the hole for the dipstick.
Use an oil with viscosity that agrees with the
temperature ranges in the figure. Refer to
data on page 29 .
-20°C -10°C
0°C
SAE10W-30
SAE5W-20
-4°F -14°F
32°F
CAUTION:
types of oil.
14. Start the engine and let it operate at idle speed for 3
minutes.
15. Stop the engine and make sure that there are no
leaks.
16. Fill with oil to make up for the oil held in the new oil
filter.
To do a check of the transmission oil
level
Note:
Do the transmission oil check when the
transmission is cool.

Troubleshooting schedule

If you cannot find a solution to your problems in this
owner's manual, speak to your Husqvarna service
agent.
1590 - 007 -
Technical
10°C
20°C
30°C
40°C
SAE40
SAE30
SAE10W-40
50°F
68°F
86°F
104°F
Do not mix different

Troubleshooting

1. Put the product on a horizontal surface.
2. Remove the screws, one on each side, and remove
the transmission cover.
3. Make sure that the oil level in the transmission oil
tank is between the 2 horizontal lines on the tank.
4. Fill with oil if the oil level is below the lower line, but
do not fill above the top line. Refer to
on page 29 for recommended oil.
Max
Min
Technical data
25

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

R 214c

Tabla de contenido