To Do A Check Of The Transmission Oil Level; To Do A Check The Oil Level In The Bevel Gear Of The Cutting Deck - Husqvarna P 520D Manual De Usuario

6. Turn the oil filter counterclockwise to remove it.
7. Lightly lubricate the rubber seal on the new oil filter
with new oil.
8. To attach the oil filter, turn it clockwise by hand until
the rubber seal is in position, then tighten a half turn
more.
9. Fill with new oil as given in
142 .
10. Start the engine and let it run at idle speed speed for
3 minutes.
11. Stop the engine and make sure that the oil filter does
not leak.
12. Do a check of the oil level.
Note: For safe disposal of used engine oil, see
on page 141 .
To do a check of the transmission
oil level
1. Use the oil dipstick to read the oil level in the
transmission.
2. The oil level must be between the marks on the
dipstick.
3. If the oil level is too low, fill with the type of oil given
Technical data on page 142 .
in
740 - 002 -
Technical data on page
Disposal
To do a check of the oil level in the
hydraulic system
1. Tilt the seat forward.
2. Clean the area around the oil cap with a dry cloth.
3. Remove the oil cap and examine the hydraulic oil
level. Correct level is 40–60 mm from the top of the
strainer.
4. If the oil level is too low, fill with the type of oil given
Technical data on page 142 .
in
To do a check the oil level in the
bevel gear of the cutting deck
1. Park the product on a level surface.
2. Lower the cutting deck to mow position.
3. Put a clean metal rod through the oil fill plug. The
metal rod must be a minimum of 100 mm long and
maximum 3 mm in diameter.
4. Lower the metal rod to the bottom of the gear
housing.
5. Pull the dipstick out and read the oil level.
6. Measure the part of the metal rod that is have oil on
it. There must be oil on 78-82 mm of the metal rod.
7. Fill with hydraulic oil if the oil level is less than 78
mm of the metal rod. Refer to
page 142 for recommended oil.
Technical data on
135