Livassured NightWatch Manual De Instrucciones página 61

Attach the clips to the slots in the arm module in a downward motion with the ends of the
band protruding from the lower end of the arm module.
Place the armband around the wearer's upper arm, while making sure the arm module is
facing forward, a little above the belly of the biceps but below the shoulder. This ensures the
wearer is unlikely to lie on the arm module when turning onto his/her side.
PLEASE NOTE: In order to achieve an assessment of epileptic seizures that is as
accurate as possible, the arm module should be worn on the upper arm (biceps) and directly
on the skin. If the wearer is wearing a pyjama top or other long-sleeved garment, please
ensure the sleeve is wide enough to wear the arm module underneath.
Check the tightness of the band. The armband will probably be a little too loose. The correct
fit allows one finger to just about fit under the strap.
If the flexible strap feels too loose:
Remove the armband, pull the flexible strap through the clips further. Try again.
If the flexible strap feels too tight:
1. Using a fingernail, press the clips from below to remove them from the arm module.
2. Adjust the clips to make the flexible strap longer.
3. Place the clips in the slots again.
Try again.
Adjust the strap until it is both comfortable for the wearer and fits snugly around the arm.
Finally, cut the excess ends off the strap so that they do not cover the green heartbeat
sensors.
V3.0
All manuals and user guides at all-guides.com
EN
61