Registering Audio/Video Equipment - Sony STR-DE905G Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Registering Audio/Video
Equipment
Registering Sony audio/video equipment
If your Sony audio and video equipment can be
controlled by an infrared remote, simply connect them
to the jacks shown on the following table, registration
is unnecessary.
Receiver jacks
Equipment to be connected
VIDEO 1
Sony VTR 3 (VHS)
VIDEO 2
Sony VTR 1 (BETA)
VIDEO 3
Sony VTR 2 (8 mm)
LD
Sony LD player
TV/DBS
Sony DBS receiver
DAT/MD
Sony DAT deck
CD
Sony CD player (CD 1)
TAPE
Sony Tape deck
MONITOR
Sony TV (via its VIDEO 1 jack)
The following cases require registration of Sony products
• When connecting a Sony MD deck to the DAT/MD
jacks.
• When connecting a Sony audio product with
CONTROL-A1 compatibility.
• When connecting a Sony product to jacks other than
those specified in the previous table (e.g., when
connecting a Sony LD player to the VIDEO 3 jacks).
• When exchanging non-Sony audio or video
equipment with a Sony product.
Notes
• If your VCR has a COMMAND CODE selector switch (for
VTR1, VTR2, or VTR3), set the switch to the applicable
setting. If your VCR has a built-in StarSight tuner, you
must set the COMMAND CODE selector switch to VTR 3.
• If your CD changer has a COMMAND MODE selector
switch (for CD 1, CD 2, or CD 3), normally it should be set
to "CD 1". However, if your CD changer has VIDEO OUT
terminals, set the command mode to "CD 2" or "CD 3"
("CD 3" should only be used when making CONTROL-A1
connections).
Preparing and Using the Remote
Registering non-Sony audio/video
equipment
If you connect audio or video equipment made by
another manufacturer, you must program the IR codes
used by the equipment before you can control it
through the receiver.
You can program up to 120 IR codes, including user IR
codes; however, depending on the type of codes
recorded, the maximum limit may be less than 100. It
may be difficult or impossible to program up to 120
codes under the following conditions:
• When programing IR codes of special remotes such
as card type remotes, or remotes for household
appliances such as air conditioners.
• When programing from remotes with weak batteries.
• When programing IR codes that have been
programed to a programmable remote (i.e., any IR
code not originally supplied in the respective
remote).
Registration
1
Click FUNCTION in the main menu.
FUNCTION
S
O
U
N
D
LIST
BAND
FM 102.50MHz
2
Click IR SET.
FUNCTION SELECT
VIDEO
1
VIDEO
2
VIDEO
3
L D
TV / DBS
MACRO
1
IR SET
ALL
OFF
VOL
+
SUB
USER
+
STEREO
DAT/MD
CD
TUNER
PHONO
TAPE
MACRO
2
EXIT
(continued)
19
EN

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Str-de805g

Tabla de contenido