Qlima ECO 1700 Instrucciones De Uso página 84

Clean the flue side of the heat ex-
changer
Check the electrical parts such as
the PCB, the wiring, the sensors
and safety devices.
Check the silicon hoses on the pres-
sure sensor
Check the door seal and replace if
necessary.
Test the stove at all 5 combustion
levels
Test the safety devices
(*) The specified frequency is a minimum. Local law and/or your insurance contract
may prevail depending on which is stricter. If the stove is used intensively, the flue
must be cleaned more frequently.
7. TECHNICAL SERVICE, ORIGINAL SPARE PARTS
Before any stove leaves the factory, it is first thoroughly tested and started up. Any
repairs or commissioning work that proves necessary during or after installation
must be carried out by a Qlima-approved heating technician. Original spare parts
are available exclusively from our Technical Service Centres and authorised sales
outlets.
Before contacting your dealer, the Technical Service Centre or the authorised heat-
ing technician make sure you have the model and serial number ready.
Only use original Qlima spare parts. The use of anything other than Qlima spare
parts will invalidate the warranty.
8 TROUBLESHOOTING
8.1 RESETTING AN ERROR
Before resetting an error, consult the error list (section 8.2) and follow the instruc-
tions. Reset the stove by pushing button 3 (see figure 2) on the display and holding
it down for 3 seconds.
If the error message reappears after resetting, consult your supplier.
4
84
Once a season or after 900 combustion
hours when the stove displays SERV
Once a season or after 900 combustion
hours when the stove displays SERV
Once a season or after 900 combustion
hours when the stove displays SERV
Twice a season; the first time at the start of
the season or after 900 combustion hours
when the stove displays SERV
Once a season or after 900 combustion
hours when the stove displays SERV
Once a season or after 900 combustion
hours when the stove displays SERV