Waypoints Mode Example; Lap Data Mode; Lap Data Mode Functions; To Operate Lap Data - Timex W-188 Guia Del Usuario

589-095006_W188_NA_EN_589-095006_W188_NA_EN 3/11/11 8:39 AM Page 46

Waypoints Mode example

As a member of a local backpacking club, you volunteer to
conduct trail clean-up before the opening of each camping
season. Your map indicates various landmarks along the trail,
but the trail itself has become overgrown. You move along the
trail, clearing the underbrush to reveal the trail and at each
landmark you set a waypoint on your Watch. When you reach
the end of your designated clean-up route, you activate the
Track Back feature to return to each landmark on your route
and ensure you have properly cleared the trail.

Lap Data Mode

INDIGLO®
night-light
To Summary
Mode or
hold
for time
46
All manuals and user guides at all-guides.com
L
data value
M
data value

Lap Data Mode functions

Lap Data Mode allows you to review stored lap information at any
time. To record lap data, you must run the chronograph.
Once you restart the chronograph from zero for your next activity,
lap data from the previous activity is erased.
NOTE: To view summary information for your entire activity,
refer to "Summary Mode" on page 49.

TO OPERATE LAP DATA

1. Press MODE until the Lap Data Mode appears.
2. Press (DISPLAY) or
L
through lap data.
Each recalled lap will display three lines of data. The lower
line will show the lap number labeled RCL (for recall) for each
lap you stored in the chronograph.

TO VIEW PERFORMANCE DATA IN LAP DATA MODE

With the exception of lap and split times, Lap Data Mode relies on
the Fitness Sensors.
If you only use one Sensor, information for the other Sensor will
appear blank if you have set the Watch to hide blank data.
For information on data hiding, refer to "Watch settings" on
page 67.
(STOP/RESET) to navigate
M
47