Gps-3D Sensor Settings; Altitude Settings - Timex W-188 Guia Del Usuario

589-095006_W188_NA_EN_589-095006_W188_NA_EN 3/11/11 8:39 AM Page 64

GPS-3D SENSOR SETTINGS

Smoothing: Smoothing is useful if you feel that the displayed
speed or pace values appear to be too erratic. Smoothing applies
an averaging filter and may cause the displayed speed or pace
values to respond more slowly to changes.
Configure the following speed and distance settings:
O Zone Type: Set the Watch to track your speed or your pace and to
alert you if you move too slowly or too quickly (alert types include
an audible alert that beeps or a silent alert that flashes).
Slowest pace
Fastest pace
NOTE: You can set speed and pace limits independently. For
instance, set pace limits to control pace for your run and
set speed limits to values useful for cycling. Then simply
switch between the settings for each activity.
O Distance Alert: Set the Watch to alert you for distance
intervals. For example, you can set the Watch to alert you for
every mile you travel. The distance alert will only function
when the chronograph is running.
64
All manuals and user guides at all-guides.com
Fastest speed
Alert
Type
Slowest speed
O Speed Smoothing: Turn speed smoothing off or on.
O Pace Smoothing: Turn pace smoothing off or on.

ALTITUDE SETTINGS

Smoothing: Smoothing is useful if you feel that the displayed
altitude values appear to be too erratic. Smoothing applies an
averaging filter and may cause the displayed altitude values to
respond more slowly to changes.
Configure the following altitude settings:
O Target Altitude: Set the target altitude to alert you when you
move above a specified altitude. When you reach the target
altitude, the Watch beeps and begins timing. If you move below
the target altitude, the Watch suspends timing until you once
again move above the target altitude.
O Max Altitude: Set the max altitude to alert you if you move
above an altitude value you do not wish to exceed. If you exceed
your altitude, the Watch will beep until you move below the
maximum altitude.
O Smoothing: Turn altitude smoothing off or on.
O Update Ascent Rate: Set the Watch to update the period at
which the ascent rate is calculated. You can choose intervals of
30 seconds, or one, 10, 30, or 60 minutes. Set this feature
shorter for faster vertical activities such as skiing or longer for
slower vertical activities such as climbing.
65