User Instructions - Easy Home DF1018 Manual Del Usuario

User instructions

1. Place the Parabolic Heater on a hard, flat, stable surface.
2. Make sure both knobs are turned to the off position.
3. Plug the power cord into an electrical outlet.
Timer
Knob
4. Turn the Timer Knob on the left to the desired setting.

ON – the heater will stay on when the Function Knob is set to the desired
heat selection.

OFF – indicates the Function and Timer are turned off.

20, 40, 60, 80, 100, 120 – You may set the heater to a specific time. The
timer settings are in increments of 20 minutes up to a maximum of 120
minutes. The heater will turn off when the timer reaches Off.
5. Turn the Function Knob to the desired heat setting.

Osc. High – is for High heat (800W) with the oscillation function.

High – is for High heat (800W) without the oscillation function.

Off – is to turn the Function Knob off.

Low – is for Low heat (400W) without the oscillation function.

Osc. Low – is for Low heat (400W) with the oscillation function.
6. The heater will not operate if the Timer Knob and Function Knob are not
turned to specific settings other than 'Off'.
7. Do not force the knobs beyond their normal stop positions.
8. If the heater does not turn on, be sure it is on a hard, flat, stable surface to
ensure the tip-over switch is activated.
9. When not in use, turn the knobs to the 'Off' positions and unplug the heater
from the electrical outlet.
User instructions
Function
Knob
7