Description And Operation; Important Safeguards - LEGRAND Wattstopper LMCP8-10V Instrucciones De Instalación

The LMCP series panels are available for Dimming (LMCPx-10V) or Switching (LMCPx) control of lighting and plug loads. The panels
can be networked together to enable automation through out an entire facility.
The HDR panel relays respond to inputs from Digital Lighting Management (DLM) switches, occupancy sensors, daylight sensors, input
modules and 0-10V outputs on dimming panel models.
Relays in each LMCP panel can be assigned to up to 99 automation groups in any combination. Each group can respond to unique
scheduled events and light/dark photocell operations set up via an LMCT-100-2 handheld configuration tool. A group can also respond
to schedules sent from a Network Controller or a BACnet-enabled building automation system (BAS). Individual loads, or groups of
loads, can also be controlled by DLM digital switches, dimmers, occupancy sensors, LMLS series daylight sensors, and LMIN-104 input
modules. Controls are assigned to relays using Push n' Learn™ directly from the user input device, or via an LMCT-100-2.
Multiple panels may be networked together for global control operation without the use of a Network Controller or BAS. The LMCP
panel also provides a native-BACnet integration solution via BACnet MS/TP, or with optional NB-ROUTER, BACnet/IP. Relay, group,
and control device status, including occupancy sensor status, are available as BACnet objects. When a Wattstopper Network Controller
is used, it will automatically recognize LMCP panels and map them to the browser-based user interface so that they can be configured
with minimal additional setup.
LMCP panels provide effective, code-compliant control of building exterior lighting as well as larger interior areas that are not suited for
DLM distributed controls. Recommended applications include office building lobbies, corridors, loading docks, etc., as well as school
gymnasiums, commons areas, hallways, any space with a hard cap ceiling, or an open ceiling where view of load controllers is not
desired. LMCP panels are also ideal for retrofit scenarios where mounting control equipment near existing branch circuit breakers is
beneficial and digital switch and sensor devices and load parameter configurability are required to meet complex operational sequences.
Before installing the LMCP, read the instructions completely. For any questions, call our Technical Support team at:
800.879.8585.
Important Installation Notices
• All power must be turned OFF prior to wiring, installation or service.
• More than one disconnect may be required to de-energize power to the LMCP.
• External circuit protection to the LMCP is required (e.g., circuit breaker).
• Installation shall be in accordance with all applicable regulations, wiring
practices, and codes.
• Care should be taken not to mix Class I and Class II wires.
• Do not energize wiring until the unit is fully assembled and connected circuits have been tested and found to be free of electrical shorts.
• The LMCP is ESD sensitive. Observe reasonable precautions.

IMPORTANT SAFEGUARDS

When using electrical equipment, basic safety precautions should always be followed including the following:
a. READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
b. Do not use outdoors.
c. Do not mount near gas or electric heaters.
d. Equipment should be mounted in locations and at heights where it will not readily be subjected to tampering by unauthorized
personnel.
e. The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.
f. Do not use this equipment for other than intended use.
g. Installation should be performed by qualified service personnel.
INTERIOR

DESCRIPTION AND OPERATION

Panel interior and enclosures
2
CAUTION
THE DB9 CABLES CANNOT BE
PLUGGED IN OR UNPLUGGED
WITHOUT POWERING DOWN THE PANEL.
ENCLOSURES