BOSKA Cheese-O-Matic Manual Del Usuario página 6

EN
REPLACING THE CUTTING WIRE
Cutting wires are available for re-order on www.boska.com, article no. 552010.
• Twist half the handle, so it comes loose from the thread.
• Slide the loop off the thread.
• Place the machine upside down.
2
• Place a small flat-head screwdriver behind
NEXT ASSY USED ON
the block in the rail, like shown in the illus-
APPLICATION
2
tration on the right. Then push the block
towards you, so the ball of the wire lines
up with the round opening in the rail.
B
UNLESS OTHERWISE SPECIFIED:
NAME
DRAWN
DIMENSIONS ARE IN INCHES
TOLERANCES:
A
CHECKED
FRACTIONAL
ANGULAR: MACH BEND
ENG APPR.
TWO PLACE DECIMAL
THREE PLACE DECIMAL
MFG APPR.
Q.A.
INTERPRET GEOMETRIC
TOLERANCING PER:
COMMENTS:
MATERIAL
Material <not specified>
FINISH
oppervlak behandeling
DO NOT SCALE DRAWING
SOLIDWORKS Educational Product. For Instructional Use Only.
SOLIDWORKS Educational Product. For Instructional Use Only.
1
2
DATE
TITLE:
SIZE DWG. NO.
A
2
PROPRIETARY AND CONFIDENTIAL
THE INFORMATION CONTAINED IN THIS
DRAWING IS THE SOLE PROPERTY OF
<INSERT COMPANY NAME HERE>. ANY
SCALE: 1:10 WEIGHT: 25207.52 SHEET 1 OF 1
REPRODUCTION IN PART OR AS A WHOLE
NEXT ASSY
WITHOUT THE WRITTEN PERMISSION OF
1
<INSERT COMPANY NAME HERE> IS
APPLICATION
PROHIBITED.
2
B
A
UNLESS OTHERWISE SPECIFIED:
DRAWN
DIMENSIONS ARE IN INCHES
TOLERANCES:
CHECKED
FRACTIONAL
ANGULAR: MACH BEND
ENG APPR.
TWO PLACE DECIMAL
THREE PLACE DECIMAL
MFG APPR.
REV
Q.A.
INTERPRET GEOMETRIC
TOLERANCING PER:
COMMENTS:
MATERIAL
Material <not specified>
FINISH
USED ON oppervlak behandeling
DO NOT SCALE DRAWING
1
NAME DATE
TITLE:
SIZE DWG. NO.
A
SCALE: 1:10 WEIG
1