skilsaw HD77 Instrucciones De Funcionamiento página 13

SM 2610905550 1/03 1/8/03
TWIST-TO-LOCK CONNECTOR INSTRUCTIONS FOR MODELS HD77 & HD77M CODE 72 ONLY
The Model HD77 & HD77M code 72 is
equipped with a "Twist-To-Lock" male
connector as shown. Use only a 3-wire
extension cord which has a mating "Twist-To-
Lock" female connector on one end and a 3-
prong grounding plug on the other end. (See
Electrical Safety section on page 2 for
grounding information.)
If an extension cord is
WARNING
!
necessary, a cord with
adequate size conductors that is capable
of carrying the current necessary for your
tool must be used. This will prevent
excessive voltage drop, loss of power or
overheating. Grounded tools must use 3-
wire extension cords that have 3-prong
plugs and receptacles.
NOTE: The smaller the gauge number, the heavier
the cord.
* Blade
* Wrench
** Carrying case
** Rip Fence
** Non-marring overshoe
4:26 PM Page 13
20 AMP, 125 VOLT "TWIST-TO-LOCK"
Accessories
RECOMMENDED SIZES OF EXTENSION CORDS
120 VOLT ALTERNATING CURRENT TOOLS
Tool's
Ampere
Rating
3-6
6-8
8-10
10-12
12-16
(*= standard equipment)
(**= optional accessories)
-13-
NEMA L5-20P
Cord Size in A.W.G. Wire Sizes in mm
Cord Length in Feet Cord Length in Meters
25 50 100 150 15 30 60 120
18 16 16 14 .75 .75 1.5 2.5
18 16 14 12 .75 1.0 2.5 4.0
18 16 14 12 .75 1.0 2.5 4.0
16 16 14 12 1.0 2.5 4.0 —
14 12 — — — — — —
2