To Adjust The Handle; Assembly; To Assemble The Grass Catcher - Husqvarna LC 247i Manual De Usuario

• Put on heavy duty gloves when you use the cutting
equipment. The blade is very sharp and cuts can
easily occur.
• Keep the cutting edges sharp and clean for the best
and safest performance.
• Let your service agent regularly examine the product
and make necessary adjustments and repairs.
Introduction
WARNING:
product, read the safety chapter.
WARNING:
during assembly, turn the safety key to 0,
remove the battery and wait at minimum 5
seconds.

To adjust the handle

1. Loosen the lower knobs.
2. Move the knobs to the lower end of the grooves on
the left and the right side of the product.
3. Set the handle height in one of the 2 available
positions.
4. Move the knobs up in the direction of the handle until
they stop and you hear a click.
5. Tighten the knobs fully.
10

Assembly

Before you assemble the
To prevent accidental start
• Obey the instructions for how to change accessories.
Only use accessories from the manufacturer.
• When not in operation, keep the product, battery and
battery charger apart in a dry, indoor and locked
area. Make sure that children and persons that are
not approved cannot get access to the product,
battery or battery charger.

To assemble the grass catcher

1. Attach the grass catcher frame to the grass bag with
the rigid part of the bag on the bottom. Keep the
handle of the frame on top of the grass bag.
2. Attach the bottom section of the grass catcher frame
in the groove on the bottom of the grass catcher.
3. Attach the grass bag to the grass catcher frame with
the clips.
4. Lift the rear cover.
5. Attach the grass catcher to the top edge of the
chassis.
6. Put the lower part of the grass catcher into the grass
discharge channel.
1696 - 003 - 16.12.2021